9
Steam Ironing
When filling the iron with water, ensure
that the iron is unplugged. Set the
Steam Control to the DRY position and
holding the iron at an angle use the
water cup supplied to fill the water
tank. Never exceed the maximum
water level as indicated (MAX) on the
side of the water tank.
Tap water can be used in your
Kambrook Steamline iron unless it
is particularly hard, in which case
it is recommended that distilled or
demineralised water be used.
To Operate the
Steam Control
As per the indications on the
Temperature Control and in
Table A (See section ‘Setting the
Temperature’) steam ironing is
only possible at higher ironing
temperatures, indicated with Cotton/
Linen on the Temperature Control.
Plug the power into a 230V or 240V
power outlet and switch the power on.
Set the Temperature Control to the
required position within the steam
range and wait until the Heating
Indicator Light has gone out.
Set the Steam Control (on top of the
handle) to the required setting.
Your Kambrook iron is now ready for use.
IMpORTANT:
If the iron is
set to a low temperature
on the Temperature
Control (i.e. synthetic
or silk) and also on any
of the steam control
settings, there may
be leakage from the
soleplate. This is due to
the iron temperature not
being high enough to
vaporise the water and
create steam.
Therefore, ensure
that the steam
control is always set
to correspond with
the setting on the
temperature control
as seen in Table A (see
section ‘Setting the
Temperature’).
KI730_KI760_KI760P_KI780_IB_FA.indd 9
19/01/10 3:40 PM
