87
GB
Now the upper section to the heat exchanger
is free from any encumbrance so as to
allow a perfect cleaning. Once a year is also
recommended to clean the upper compartment
of the exchanger. To make a proper cleaning
is recommended to suck the ash, remove all
horizontal joints with a screwdriver, then again
suck the ash.
Following the cleaning of the upper
compartment of the exchange
section, store the upper closure cover.
This cover must be closed, as well as with
normal screws, with webbing in ceramic fiber
rope to ensure the watertight closure of the
thermostove.
This general cleaning should be carried out at
the end of the season in order to facilitate the
general removal of all residues of combustion,
without waiting too long, because with time
and humidity these residues can become
compacted. Check the seal of the ceramic fiber
gaskets on the door of the thermostove.
Then clean the flue system especially near the
fittings to “T” and any horizontal sections.
In case of failure or inadequate cleaning of
the heater may have function problems such
as:
• poor combustion
• blackening of the glass
• clogging of grate with accumulation of ash
and pellets
• ash deposit and excessive deposits on the
heat exchanger resulting in poor performance.
For your safety, the frequency of
cleaning the smoke discharge
system must be determined on the
basis of how the thermostove is
used.
We recommend that an annual maintenance
service is carried out, preferably under a
programmed service contract. The essential part
of this service is a visual and functional check on
the following components:
• reduction motor
• smoke expulsion fan
• smoke sensor
• ignition sparkplug
• resettable pellet thermostat
• room temperature sensor
• pressostat
• motherboard
• fuse protecting panel - motherboard
These operations must be
performed by a qualified
technician, or the user who will
take responsibility in the event of
damage during maintenance.
Perform this maintenance heater cold
and in the absence of electricity. If such
maintenance is performed by an authorized
service center is the responsibility of the
customer.
Surface cleaning
The thermostove is a product by heating,
presents the external surfaces particularly hot.
For this reason, we recommend extreme caution
when operating in particular:
• Do not touch the thermostove body and the
various components, do not approach the door,
it could cause burns;
• Do not touch the exhaust fumes;
• Do not perform any type of cleaning;
• Do not dump the ashes;
• Do not open the ash tray;
• Be careful that children do not come close.
All cleaning of all parts must be carried out with
the stove completely cold and the plug discon-
nected.
To clean the surfaces, use a rag dampened with
water or with water and a neutral detergent.
The check of electromechanical
components must be performed
only by qualified personnel with
technical knowledge of electricity and
combustion.
Summary of Contents for Alessia
Page 47: ...93 GB NOTES Cod 001143...
