Kalmar Ottawa, Operator'S Manual

Page: 7 / 59

6
Owner Information
AXLE-FRONT
Maintaining correct front axle alignment
is critical and should be performed by a
qualified mechanic.
Check to ensure that the axle mounting
bolts are securely tightened. Regularly
check the front axle for damage, binding
or worn parts, and adequate lubrication.
Pay special attention to the axle stops
and rubber snubbers. Do not operate the
vehicle without the proper axle stops in
place.
AXLE - REAR
Check to ensure that the axle mounting
bolts are securely tightened. Regularly
check the rear axle for damage and oil
leaks. Unusual noises and signs of extreme
heat may indicate axle damage.
BRAKE SYSTEM
Check the following:
1. Check brake controls for proper opera-
tion. Make sure the foot operated treadle
in the cab is operating smoothly and is
not damaged.
2. Visually inspect the brake drums, brake
chambers, and slack adjusters. Check for
loose, missing or broken components.
Check brake chambers and slack adjusters
for cracks and other signs of sever wear.
3. Listen for air leaks in the cab and un-
derneath the chassis. Check air pressure
regularly using the dash mounted gauge.
Be alert for any sudden drops in pressure
while operating the vehicle and after the
engine is shut off. A minimum air pressure
of 70 PSI is required to operate
this vehicle.
4. Visually check hoses and pneumatic
lines for damage and chaffing.
5. Check the operation of both the service
and parking brake systems. Be alert for
any reduction in braking performance or
unusual noises while braking.
CAB
Defroster - Operate the defroster to make
sure sufficient air is being directed against
the windshield. Make sure the blower is
operating before the weather requires the
defroster.
Door Latches - Check for positive closing,
latching and locking.
Walkways/Side Step - Check to ensure
that all factory installed walkways, plat-
forms and steps are installed on vehicle
securely and are not damaged or loose.
Handholds/Grab Handles - Check to en-
sure all handholds are installed and are
not loose or damaged.
Glass - Check for cracked, broken,
scratched or dirty glass.
Cleaning instructions for optional plas-
tic glazing - Wash window with a clean
sponge or soft cloth using lukewarm water
and mild detergent or window cleaner.
Rinse with clean water. Do not use
abrasive highly alkaline cleaners. Never
scrape with squeegees, razor blades, or
other sharp instruments. Remove ice and
frost with the cab heater/defroster or by
applying heat.
Mirrors - Check to be certain all mirrors
are installed and that they are clean, un-