INSTALLATION INSTRUCTIONS
Vanity
1207801-2-
B
© 2013 KALLISTA
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
8 of 8
6. ReMOVe/ADjUST The DRAweR
Rail
Tab
Underside View
Release Latch
Drawer Height
Adjustment Wheel
NOTe:
A drawer height adjustment wheel and a release latch are located underneath the front of the drawer at
each corner.
Removal:
Slide the drawer out on the rails until fully extended.
Pull both release latches toward you and then pull the front of the drawer up off the rails.
Lift the drawer out from the vanity.
Reinstallion:
Fully extend the rails.
Align the grooves on the underside of the drawer with the rails and set the drawer into place.
Hold the drawer in place on the rails with one hand. With your other hand, pull the tab on the bottom front of
the rail toward you until you hear the rail “snap” into place. Repeat this step for the remaining rail.
Ensure the drawer is locked into place by lightly lifting the front of the drawer upward. If the drawer does not
lift up, it is engaged. If the drawer lifts up, repeat the procedure.
Slide the drawer in and out of the vanity to ensure smooth operation.
Adjustment
Slide the drawer out on the rails until fully extended.
Turn the drawer height adjustment wheels to adjust the drawer height. To lower the drawer, turn the wheel on
the left side of the drawer clockwise and/or the wheel on the right side of the drawer counterclockwise. Turn
the wheel(s) in the opposite direction to raise the drawer.
