background image

INSTALLATION INSTRUCTIONS

Original For Him Dressing Table 

1008300_2_A

2 of 6

Questions?   Problems?   For additional assistance, please contact Kallista’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.

We appreciate your commitment to Kallista quality products. Please take a moment to review this manual 

before you install your Kallista product. If you encounter any installation or performance problems, please do 

not hesitate to contact us at the phone number listed at the bottom of the page.

BefORe yOU BegIN

 

‰

These instructions are for installing the dressing table (P73015) and pre-cut marble top (P73032).

 

‰

Observe all local plumbing and building codes.

 

‰

Prior to installation, unpack the new dressing table and marble top and inspect them for damage. Return 

the dressing table and marble top to their protective cartons until you are ready to install them.

 

‰

Refer to the dressing table specification sheet for P-trap and supply location recommendations. Verify your 

supply valves and P-trap will not interfere with the shelf and drawer. Install the water supply and drain lines. 

The water supply nipples must extend 3″ (76 mm) beyond the finished wall material.

 

‰

These instructions are for installing the dressing table to wood frame construction. For other installations, 

supply suitable bracing and fastening devices of sufficient size and strength.

 

‰

Provide 2x6 backing material in the finished wall. The height from the top of the 2x6 backing material to the 

floor must be 36-1/4″ (921 mm).

 

‰

This installation is recommended to be done with a minimum of two people.

 

‰

The marble top can be installed with three different faucet configurations:

 

● ″Single-Hole″ for a monoblock faucet

 

● ″Three-Hole″ for a widespread faucet

 

● ″No-Hole″ for a wall-mount faucet

 

‰

All dimensions given assume that the floor and walls are square, plumb, and level. Make appropriate 

adjustments for other conditions.

 

‰

Remove any moldings that may inhibit the dressing table from being flush against the finished wall.

 

‰

Make sure the path of the shelf will not be obstructed as it slides open.

 

‰

Kallista reserves the right to make revisions in the design of products without notice, as specified in the 

Price Book.

 

‰

ThANk yOU fOR ChOOSINg kALLISTA

TOOLS ANd MATeRIALS 

Pencil

Tape

Measure

Level

Drill

Hex

Wrench

Clear 100% Silicone

Sealant or Caulk

File

Hammer

Safety Glasses

Plus

●  Conventional woodworking 

tools and materials, as 

appropriate

●  Hole Saw

●  Wood Screws

●  Screwdriver  

Reviews: