INSTALLATION INSTRUCTIONS
Original For Him Dressing Table
1008300_2_A
5 of 6
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
NOTE:
If using a lavatory with overflow, ensure that the
lavatory is installed with the overflow to the front of the marble
top and dressing table.
Install the lavatory and faucet to the marble top at this
time. Refer to the lavatory manufacturer’s instructions
for proper lavatory installation. Refer to the faucet
manufacturer’s instructions for proper faucet installation.
With the help of an assistant, place the marble top on top
of the dressing table. Verify correct fit and alignment of all
components. Adjust as necessary.
With the help of an assistant, carefully remove the marble
top and set aside.
Drill two pilot holes through the mounting rail and finished
wall on each side of the dressing table. Make sure the two
pilot holes are spaced a minimum of 16″ (406 mm) apart
from one another.
Tighten a wood screw through each of the two drilled
holes until the dressing table is flush and secure against
the finished wall.
Apply clear 100% silicone caulk or sealant to the top of the dressing table.
With the help of an assistant, replace the marble top on top of the dressing table. Verify correct fit and
alignment. Adjust as necessary.
Install the P-trap according to the manufacturer’s instructions.
Connect the water supply and check all connections for leaks. Repair as needed.
4. INSTALL The MARBLe TOP
5. COMPLeTe The INSTALLATION
