INSTALLATION INSTRUCTIONS
Deck-Mounted Bath Set with Diverter
1242694-2-A
4 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
2. INSTALL THE SPOUT
Diverter Body
Diverter
Tube
Spout Assembly
Setscrews
Plug
Lift Rod
Stem
Setscrew
Extension
Lift Knob
Finished Deck
Plug
NOTICE: To avoid damage to the o-rings, keep them clean and free of debris.
Lift up and hold the stem of the diverter body with a pair of pliers, then fully insert the lift rod.
Install the diverter tube over the lift rod and into the diverter body.
Loosen the setscrews on the spout assembly until they are clear of the inside wall of the spout.
Apply a ring of plumbers putty or other suitable sealant around the underside of the spout base.
Position the spout over the diverter tube, then carefully press down until the spout contacts the fi nished
deck.
Rotate the spout until it is aligned to face straight forward.
Retighten the setcrews.
Push the plugs into place over the setscrews.
Install the lift knob extension over the diverter tube on the back side of the spout.
Thread the setscrew into the lift knob extension until tight.
Thread the lift knob onto the setscrew. Tighten until the knob is fl ush with the extension.
Remove any excess plumbers putty or sealant.
