INSTALLATION INSTRUCTIONS
Bidet Faucet
1087125_2_B
3 of 5
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
LIFT ROd eSCUTCheON INSTALLATION
2.
Brass
Washer
Escutcheon
Apply
Plumbers
Putty.
Washer
Nut
Apply a bead of plumbers putty or other sealant to the underside of the
escutcheon according to the putty manufacturer’s instructions.
Insert the escutcheon through the mounting hole from above.
From the underside of the bidet, slide the washer (tapered side up), brass
washer, and nut onto the escutcheon shank.
Securely tighten the nut with a wrench. Do not overtighten.
Remove any excess putty or sealant.
dRAIN INSTALLATION
3.
Apply plumbers
putty.
Flange
Gasket
Washer
Nut
Drain Body
Remove the protective cover from the flange.
Apply a ring of plumbers putty or other sealant to the underside of the flange
according to the putty manufacturer’s instructions.
Assemble the nut, flat washer, and tapered gasket (tapered side up) fully onto
the body.
From the underside of the fixture, insert the drain body up into the drain hole.
From the top of the fixture, securely hand tighten the flange onto the drain
body.
Make sure the drain body seal hole is facing the back of the fixture, and
securely tighten the nut.
Remove any excess putty or sealant.
COMPLeTe dRAIN INSTALLATION
4.
Body
Rod
Clip
Stopper
Nut
Flange
Nut
Tailpiece
Apply
thread
sealant.
Thumb
Screw
Stopper Rod
Link
Insert the stopper into the flange.
For regular installations, insert the short end of the rod into the body
seal hole and under the stopper. For vandal-resistant installations, fit
the rod through the hole in the stopper. Hand tighten the body nut.
Remove and adjust the stopper as needed so it lifts about 3/8” (1 cm)
when opened. To adjust, rotate the threaded stopper rod in or out as
needed. Retighten the stopper nut.
Apply thread sealant tape to the tail piece threads, and thread the tail
piece to the body. Tighten the tail piece securely.
Slide one end of the clip on to the rod. Slide the link onto the rod with
the thumb screw facing the back of the fixture.