INSTALLATION INSTRUCTIONS
Single Basin Stainless Steel Sink
1154432-2-
C
2 of 8
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
THANK YOU FOR CHOOSING KALLISTA
We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual
before you install your KALLISTA product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.
BEFORE YOU BEGIN
CAUTION: Risk of personal injury.
Use gloves and handle sink edges carefully. Metal surfaces are
sharp and can cause severe cuts.
Please read all instructions before you begin.
Observe all local plumbing and building codes.
Shut off the water supply.
The appearance of your product may differ from what is shown in these instructions, however, the
installation procedure is the same.
This guide contains two installation methods. Carefully read this entire instruction manual before beginning
the installation to determine the appropriate method for your installation.
Measure the cabinet opening where the sink will be installed. Plan for adequate clearance between the
faucet handles and the backsplash or finished wall.
The number of clips included with your sink may differ from the number of clips illustrated. Use all clips
included with the sink.
Countertop manufacturer/installer should install the anchors into the underside of the countertop. Use the
anchors and fasteners provided by the countertop manufacturer and the clamps provided with your sink.
Clean the underside of the countertop at the sink installation area thoroughly before installing the sink.
Allow the sealant to cure following the sealant manufacturer’s instructions.
KALLISTA reserves the right to make revisions in the design of products without notice, as specified in the
Price Book.
TOOLS AND MATERIALS
Plus
• Conventional woodworking
tools and materials, as
appropriate
• Saw
• Screws
• Screwdriver
Clear 100% Silicone
Sealant or Caulk
