Kalkhoff Bosch Cruise, User Manual

Page: 252 / 550

16 VIII User Manual Pedelec Xion
5.2.3 Battery charge state indicator
The battery charge state indicator is located to the right of
the centre of the display. Using a stylised battery divided
into four segments, it shows the charge remaining in the
battery. The lower the
charge state of the battery is, the
fewer segments are displayed.
If the battery charge state falls below a minimum level,
the assistance switches off via the motor. The display
remains active until the battery reaches the lowest pos-
sible charge state.
If you do not move your Pedelec for 10 minutes, the sys-
tem switches off automatically. If you subsequently want
to ride using the assistance, you will have to switch it
back on using the diamond button.
5.2.4 Remaining range indicator
To the right of the display of the power-assist mode, the
distance in km over which you can still travel with power
assist is displayed. This is the remaining range indicator.
This “remaining range” is calculated using two meas-
urements taken during the current journey. One short
and one long measurement give a representative av-
erage value. If the conditions of the journey change,
for example, by riding up an incline after a long, flat
stretch, the value displayed can also change at short
notice. Please consider this factor when planning your
trips. You are probably familiar with this effect from
the remaining range indicator of your car.
Charge state indicator
1 Battery full
2 Battery almost empty
1 2
5.2.5 Pushing assistance
First of all, pushing assistance must be activated in
programming mode
(
➠
Chapter 5.4.4 “Pushing assis-
tance”) .
To activate the pushing assistance, press and hold the
upper arrow button. To receive no further pushing assis-
tance, release the button.
5.3 Troubleshooting
If your bike has been exposed to wet conditions for
an extended period, e.g. after a trip in heavy rain, or
if there have been large differences in temperature,
the screen of the display may steam up. This mois-
ture does not impair the function of the display. It is
comparable with the steam on a pair of glasses when
you enter a warmer room having been outside. After
a short time in drier and warmer conditions, this con-
densation will vanish leaving no trace.
Error messages do not appear on the entire screen, but
rather in place of the battery display on the right-hand
side. All symbols remain permanently visible, with the
exception of the “Inspection due” symbol.
SYMBOL CAUSE SOLUTION
Battery almost
empty.
•
Recharge your
battery.
Inspection due.
•
Consult your spe-
cialist cycle shop.
Temperature is
too high. The
motor is too hot.
•
Allow your system
to cool down.
A fault has
occurred in the
system.
•
Please contact
your specialist
cycle shop.