Chapter 2. Setup
15
Note:
If you are using a wireless keyboard / mouse set, plug the receiver
into the Keyboard Port.
3.
Connect your mouse to the Mouse Port.
4.
Connect the USB connection Port 1, 2, or 3 to a USB port on the PC.
Note:
It is recommended to use Port 1 for PC and Port 2/3 for games
consoles. If you are only connecting game consoles use Port 1 for
the first console.
5.
If Port 1 is already used for connection of another PC or other game
console, connect this PC to Port 2 or 3 as explained in step 4.
6.
If Port 1 and Port 2 are already used, connect your PC to Port 3 using a
micro USB cable (not supplied). After connecting the micro USB to Port
3, connect the USB end as explained in Step 4.
7.
Connect the KeyMander 2 3Play to a 5V/2A DC power supply if
necessary. If your KeyMander 2 LED is flashing red or you receive a low
voltage notification on the K2 App, you need to connect an additional
5V/2A USB power supply (not included).
Note:
Some RGB keyboards and nearly all keyboards with built-in USB
ports or headphone jacks require more power than KeyMander 2
3Play can provide, so an external USB power supply (minimum 2
amps) is required.
8.
Turn on the PC, wait for it to boot and recognize the KeyMander 2 3Play
is connected. The KeyMander 2 3Play’s LED will be glowing white.
9.
After the PC has booted, confirm the mouse and keyboard are working,
then press your mouse DPI button to change to your preferred DPI setting
for use with the PC. If your PC screen is set to a lower resolution setting,
you may find a lower setting of 800-2000 DPI on your mouse works best
when your KeyMander 3Play is focused on your PC. If you have a large
or high-resolution monitor, you may find the same DPI setting you use
with your game console, which our recommendation is 3500-4000 DPI or
higher also works fine when switching focus to PC. If you need to change
your mouse’s pre-programmed DPI settings, you will first need to connect
your mouse directly to the PC so the driver can see your mouse, make
your changes and save them to the mouse, then unplug from the PC and
reconnect the mouse to the KeyMander 2 3Play when done
10.
Press the Bluetooth Pairing Button to put KeyMander 2 3Play into pairing
mode, then press the Connect button on the Device tab of the K2 App on
Summary of Contents for KeyMander 2 3Play
