INSTALLATION GUIDE
KALE FANS
www.kalefans.net
INSTALLATION GUIDE
EURUS
-14-
-13-
M12x60mm fasteners
7
Install Motor
Fix 4 pcs turnbuckles on the motor, and connect motor with extension tube, adjust the bottom of
motor to balance with level-meter(e), then tighten fasteners with 24# open end wrench(g), speed
wrench(f) and 24#socket wrench(o.
M16x120mm fastener
flat washer
flat washer
spring washer
turnbuckle
PS: keep the motor balance
and tighten the fasteners
level-meter
6
Install Safety Ring
Put wire through a small hole on extension tube, and then twist the whole beam, adjust the safety wire and tighten the guy
wire locks with speed wrench(f) and 10# socket wrench(r).
safety steel guy wire
guy wire lock
9
Install Safety Steel Guy Wire
Please pre-judge the 4 points can bear the force or not, put the wire through the hole punched beforehand on the purlin.
Connect turnbuckle with eyebolt on motor with guy wire, then loosen the turnbuckle at the most and put guy wire through
lock and connect turnbuckle. Four safety wires must be isometric, symmetrical and even load. At last tighten all wire locks
with speed wrench(f) and 10# socket wrench(r), and paint with screw glue on locks and turnbuckle.
force bearing point
to keep motor balanced.
8
Wiring on Motor
Strip the cable with wire stripper(k) and keep copper wire unbroken. Connect four lines with the same color, and fix the
connector with cross screwdriver(l), then packed with insulated rubber tape to avoid sparks and improper contact.
yellow-green
blue
red
yellow
10
Wiring for Control Box
Cable routing should be neat and good-looking, every 1.5M with a cable clip while laying cable, and then tighten cable clips
on beam and wall with straight screwdriver(m).
Please lay cable according to site surrounding
cable
cable clip
cable clip
11
Install Fan Blade
Install the fan blades on the opposite as first to keep the whole balanced, be tender for the fan blade and keep
unbroken while installing and tighten fasteners with 18# open end wrench(h), speed wrench(f) and 19# socket wrench(p).
After installation, remove off the protective cover on the fan blades.
flat washer
spring washer
cable pipe and then to lay
9
11
steel guy wire
11
10
13
18
12
guy wire lock
12
16
5
14