16
CONNECTING TO THE POWER NETWORK
• T
he supply voltage corresponds to the
specifications on the data plate
in the interior of
the device
.
If the appliance is to be connected directly to mains
terminals, fit a switch with minimum aperture of 3 mm
between the contacts. Make sure that the switch is of
sufficient capacity for the power specified on the
appliance's data plate, and compliant with applicable
regulations. The switch must not break the yellow-
green earth wire. The socket or switch must be easily
reachable with the oven fully installed.
• The power network
has an efficient ground
connection complying with all applicable laws
and regulations.
Before connecting the oven to the mains power supply,
make sure that:
T
he according to the rules installed
socket
is a legal
requirement. The power cable should never reach a
temperature 50° C above ambient temperature at any
point along its length.
After connecting the device to the power supply
network (in accordance with the requirements defined
above) it is necessary to check the lighting of the hood
and whether its motor works correctly.
EN
Attention!
The manufacturer declines all
responsibility for damage or injury if the above
instructions and normal safety precautions are not
respected
Attention!
Failure to install the screws or wall
hanger in accordance with these instructions may
result in electrical hazards.
