CAMERA SETTINGS
SYSTEM SETTINGS
11 - ENG
12 - ENG
Toggle the menu beep noise on/off.
White Balance
Manually control the white balance. Camera is
set to Auto by default.
Options include Auto, Daylight, Cloudy,
Fluorescent, Fluorescent 1, Fluorescent 2 and
Incandescent.
EV
Manually control the exposure/amount of light
the camera records.
Select EV level on the slider using the two
buttons.
ISO
Manually control the ISO level the camera
captures footage at. The default option is Auto.
Note that the higher the ISO number the more
noise/grain will appear in your footage.
Select your desired language here.
Frequency
Default setting is 50hz. However, if you
experience any light strobing in your footage
you may manually select 50/60hz.
Frequency
Default setting is 50hz. However, if you
experience any light strobing in your footage
you may manually select 50/60hz.
Inverse Mode
Select to invert the X250 menus. Useful for
mounting the camera in hard to reach places.
Screensaver
This setting lets you conserve power while
shooting. Toggle if/how long until the
screensaver comes on.
Interval options
Auto/100/200/400/800/1600/3200.
Effects
Select to apply effects to images you capture.
Available effects are Sepia/Black & White/
Negative.
Contrast
Adjust the contrast level using the buttons
on top.
Saturation
Adjust the saturation using the buttons on top.
Sharpness
Adjust the sharpness using the buttons on top.
The LCD display will go black but recording
will continue.
Car Mode
Car Mode lets you use the X250 camera like a
Dash Camera and record in Loop Mode.
When enabled the X250 will begin recording
the moment a power input/source has been
detected.
When the power source has been shut off/
disconnected the camera will record for an
interval (see delay section) and then power off.
