91
CONTROLLER FOR THE AIR SOURCE HEAT PUMP WATER HEATER
EN
3. INTRODUCTION TO LCD ICONS
1
Display of Common Operation
Modes:
HOTWATER, SAVE, PRESET and NIGHT
mode.
6
Display of defrost, antifreeze
running, and e-heater running
(or display of the Special E-HEATER Mode).
2
Display of RAPID and I-KNOW
function.
7
Display of hot water volume
(this function is unavailable to models
with single temperature sensor).
3
Display of CYCLE, STERILIZE,
SUNFLOWER, ABSENCE,
VACATION, and ONCE function
(the STERILIZE function may not
work for models without an electrical
heater).
8
Display of operating/standby.
4
Display of Keypad Lock function.
9
Display of actual water temperature,
temperature setpoint, error codes,
and running parameters.
5
Display of system time, preset time,
timer setting and running
parameters.
10
Display of the sub-controller.
(This function is reserved.)
4. OPERATION MODES
4.1 Common Modes
Mode Name
Description
HOTWATER
In the standard hot water mode, the uint will start or stop based on
the difference between the temperature setpoint and the actual water
temperature. If the temperature setpoint is higher than that can be
achieved by the heat pump, only the electrical heater will be used for
heating when the heat pump is unavailable.)
