97
CONTROLLER FOR THE AIR SOURCE HEAT PUMP WATER HEATER
EN
6.5.3 Preset Time Setting
In the PRESET mode, hot water is prepared in advance by the preset time.
In the main interface of the PRESET mode, press the
TIMER
button to enter the selection inter
-
face. PRESET 1 blinks while PRESET 2 and PRESET 3 are not displayed. Press
▲
or
▼
and the LCD
blinks circularly in the flowing sequence: PRESET 1 – PRESET 2 – PRESET 3 – PRESET 1.
Preset time setting:
Press the
TIMER
button to select PRESET 1. Then the PRESET 1 icon is on
and the hour value blinks. Press
▲
or
▼
to adjust the hour value and press the TIMER button to
confirm setting. Then the minute value flickers. Press
▲
or
▼
to adjust the minute value and press
the
TIMER
button to confirm setting. After time setting for PRESET 1 is saved, the main interface
is displayed.
PRESET 2 or PRESET 3 setting:
Press the
TIMER
button to select PRESET 2 and then the ON icon
blinks. Press
▲
or
▼
to switch the ON and OFF icons. When the ON icon blinks, press the TIMER
button. Then the PRESET 2 icon is on and the ON icon is off. The hour value blinks. Press
▲
or
▼
to adjust the hour value and press the
TIMER
button to confirm setting. Then the minute value
flickers. Press
▲
or
▼
to adjust the minute value and press the
TIMER
button to confirm setting.
After time setting for PRESET 2 is saved, the main interface is displayed. The method for setting
PRESET 3 is the same as that for PRESET 2. (After setting is saved, the ON and OFF icons are not
displayed in the main interface as these icons are available in the setting process.)
In the time presetting process, if no button is pressed within 15 seconds the preset interface will
switch to the main interface automatically and setting will not be saved.
If the time preset for PRESET 1, PRESET 2, and PRESET 3 is the same, it is regarded as one timer.
The preset time can be memorized. If the preset time does not need to be reset, users only need
to select on or off.
Preset time cancelling:
After time is preset for PRESET 2 or PRESET 3, users can press the
TIMER
button to display the selection interface. The icon of PRESET 2 blinks. Press
▲
or
▼
and the LCD
blinks circularly in the flowing sequence: PRESET 2 – PRESET 3 – PRESET 1 – PRESET 2. Select
PRESET 2 and press the TIMER button. Select to cancel PRESET 2. Then the PRESET 2 icon is on
and the ON icon blinks. Press
▲
or
▼
to select OFF. Press the
TIMER
button to confirm cancelling
and return to the main interface. The method for cancelling preset time for PRESET 3 is the same
as that for PRESET 2. Preset time for PRESET 1 cannot be cancelled. If users select PRESET 1, the
time setting interface will be displayed.
The PRESET mode runs circularly. The water heater starts to heat up water based on the preset
time and ambient temperature and stops one hour after the preset time.
