3
A.
HARDWARE DISASSEMBLY
A-1
Remove Adams-Rite face plate from
edge of door exposing the cylinder set
screws
(See Figure 1)
.
A-2
Loosen the cylinder set screw (securing
key cylinder to Adams-Rite latch) and
remove the mortise cylinder from the
dead latch assembly
(See Figure 1)
.
A-3
With the exception of the Adams-Rite dead
latch assembly, remove all other hardware
from door: knob, handle, etc
(See Figure 1)
.
CAM PLUG HANDLING
A-4
Determine the required handing of cam
disc on Adams-Rite cam plug #4580
(See
Figure 2)
. Looking at the edge of the door,
determine on which side the lock is to be
installed.
Note
: Factory cam plug handing is RH.
If the cam disc handing needs to be changed, proceed with steps A to D.
If not, proceed to Section B-1.
A.
Remove the retainer clip from the pivot pin.
B.
Pull the cam pivot pin out of the disc.
Note
: Do not remove the driver piece.
C.
Turn the cam over and push the cam pivot pin through the cam and
into the disc.
D.
Reinstall the retainer clip onto the cam pivot pin.
FIGURE 1
Narrow
Stile
Adams-Rite
Dead Latch
Assembly
Adams-Rite Face Plate
Adams-Rite
Cam Plug in
Cylinder Hole
Part #4580
Adams-Rite
Cam Plug
Part #4580
(Backside)
Mortise
Cylinder
Cylinder
Set Screw
A
B
C
D
FIGURE 2
IF IT IS TO BE
THIS SIDE
THE CAM DISC
SHOULD BE HANDED
AS SHOWN BELOW
IF IT IS TO BE
THIS SIDE
THE CAM DISC
SHOULD BE HANDED
AS SHOWN BELOW
