Kit Contents
1. Combo Motor (1)
2. Torx Screws for X-09 Combo Motor (3)
3. Flat Head Screws for CDX-09 Combo Motor (2)
4. Back Cover Screws (2)
To Remove the Old Motor
Caution: Use of a grounding strap is necessary to prevent electrostatic discharge when
performing any maintenance on the X-09 Lock. Please read instructions completely
before performing any operation.
1. Open the container or door to expose the back cover of
the lock.
2. Locate the Lock On Back Cover (LOBC) Pin on the back
cover. (Figure 1)
3. With the container/door open, turn the dial to the left and fully
extend the lock bolt.
4. Dial the combination(s) to open the lock. When OP is
displayed, pull out on the LOBC Pin and continue to hold
outward pressure on the LOBC Pin while retracting the lock
bolt. If this action is successful, the Pin will “pop” out of the
locked position, and the back cover can be removed. (If
unsuccessful, repeat until successful.)
5. Remove the two back cover screws and remove the
back cover.
6. Extend the bolt by turning the dial to the left.
7. Remove the nut that holds the drive cam to the spindle using
a 5/16” nut driver. Because of the clutch in the dial, it may
be necessary to hold the drive cam while removing the nut.
Remove and save the drive cam.
8. Locate the Combo Motor. For X-09 remove the two Torx
screws. (This will require a T8 Torx wrench.) For CDX-09
remove the two flat head screws that hold the shield and
Combo Motor in place.
9. Remove the old motor (and also the shield if CDX-09.) (Figure 2)
Note the position of the Combo Motor gear. (Figure 3)
10. Remove the fence. (Figure 4)
11. Using a small Phillips screw driver, remove the screw that holds the
slide retainer. Remove the slide retainer. (Figure 5)
Caution:
Do
not
remove metal gears. If removed, ensure roller
remains on post on back of gear, and ensure timing marks of 2
metal gears are aligned. (See Figure 6.)
X-09
TM
C
oMbo
M
oTor
r
eplaCeMenT
K
iT
(p/n 507101)
Document Number 537.026 Rev. B 07/06
Figure 2 - Locate Combo Motor
Combo Motor
Figure 1 - Lock On Back Cover Pin
LOBC Pin
Home Position
Figure 3 - Note Gear Position
5. LOBC (Lock on Back Cover) Pin, Spring, Clip
(1 each)
6. Fence (1)
7. Slide Retainer (1)
8. Phillips Head Screw for Slide Retainer (1)
