To Install the New Motor
Note: The slide retainer and fence must also be replaced since the old parts will not work with
the new Combo Motor.
1. Install the new slide retainer. (Extra screw provided.)
2. Install the new fence, ensuring that the slot in the fence is seated over the slide retainer.
3.
Rotate the new Combo Motor gear so that the motor is in the home position
and install the new
motor. Secure with the two Torx screws for X-09 or two flat head screws for CDX-09. (Extra screws
included in kit. Refer to Figures 2 and 3.)
4. Replace the drive cam and drive cam retaining nut. Once again, it may be necessary to hold the drive
cam while tightening the nut.
5. Remove the LOBC Pin from the back cover assembly by taking a pair of wire cutters and cutting the
black retainer clip on the Pin. Remove the spring and Pin from the card. This will allow you to install
the card and retract the bolt.
6. Install the back cover without the LOBC Pin, making sure the connector pins and the spindle hole in
the back cover are aligned properly, and push the cover onto the lock case. Insert and tighten the two
back cover mounting screws.
7. Test the operation of the lock by dialing the combination(s) and retracting the bolt.
8. Leave the bolt in the fully retracted position and remove
the back cover assembly.
9. Insert the cover lock pin through the back cover.
10. Install the enclosed cover lock spring and retainer clip
onto the cover lock pin. The “fingers” of the retainer clip
should be angled away from the cover lock spring, and
the retainer clip must be seated in the groove of the cover
lock pin. (See Figure 7.)
Caution:
Do not push the clip retainer past the small groove
in the cover lock pin. If the clip is not located in the pin
groove, it can interfere with pulling the bolt or prevent
withdrawal of the pin for normal back cover removal.
11. Make sure the bolt is fully retracted and reinstall the back cover with the cover lock pin in place.
Caution:
Take care to align the connectors, the spindle to the hole in the back cover, and the cover
lock pin to the keyhole slot in the bolt rack.
12. Tighten the mounting screws.
13. After restoring the bolt to the extended position, verify that the cover lock pin is fully recessed into the
back cover. If not, gently wiggle the cover lock pin to seat it.
14. Check the operation of the lock three times before closing the drawer/door and make sure the lock
operates smoothly.
Lock On Back
Cover Pin
Retainer
Clip
Cover Lock
Spring
Figure 7 - Back Cover Assembly
Figure 5 - Remove Slide Retainer
Figure 4 - Remove Fence
Fence
Slide Retainer
www.kaba-mas.com
749 W. Short Street, Lexington, KY 40508
Phone (800) 950-4744 or (859) 253-4744 FAX (859) 253-4748
Figure 6 - Do Not Remove
Metal Gears
Timing
Marks
