PK3520_09_07 • REMOTE ACCESS CONTROLLER - 660G XT
21
5. Programming and Auditing Troubleshooting
Symptom
Action
Cannot program or audit the RAC 660G XT
- Verify that the RAC 660G XT controller is active: the D43 LED should blink.
If not, reset the RAC 660G XT Controller (press the Reset switch (SW1) or
disconnect and reconnect the power).
- Verify that the 660G XT enters programming mode when *,#,*,#, is pressed,
or when a DIP switch (SW2) is toggled. The D45 LED blinks when the 660G is
in programming mode.
- The 660G controller must still be in programming mode with LED (D45)
blinking when the Program or Audit command is selected on the M-Unit.
- Verify that the M-Unit is pointing toward the infrared Transceiver (D12) located
beside the DIP switch (SW2) during programming and auditing. The distance
between the M-Unit and the 660G controller should be a few inches (3 to 6
inches).
- If the RAC 660G XT is not initialized (Initialization LED, D41, is OFF) it needs to
be programmed:
• Follow the instructions in Section 5.2 “Programming using a PALM”
- If the RAC 660G XT was already initialized, it may need to be re-initialized:
• Follow the instructions in section 5.3 “Reset to factory default”.