7
The lock will reset. A green light with corresponding high pitch tone indicates
reset is complete and successful.
Lock is now reset to the factory mode and the Master Code is now
1-2-3-4-5-6-7-8.
*M-Unit is only applicable when using optional E-Plex software.
PROCEDURE 1 - PROGRAM THE ACCESS CODE
LENGTH
Setting the length of Access Codes must be the first lock programmable func-
tion you perform, because all your other access codes must have the same
length. If a user enters a code of a different length, the lock will not accept it.
Longer length Access Codes permit a greater number of code possibilities, and
thus higher security. The master code must always be 8 digits. This length can
not be changed.
Required User Level: Master
1. To configure the E-Plex Lock programmable pushbutton lock, it must first
be placed in Programming Mode.
Important: This is the only programmable function that can be done
during the factory mode using the factory master code. Except for
changing from the factory code to a new master code.
2. Enter the E-Plex Lock factory Master (Programming) Code
(
#12345678#
). The lock responds with a flashing green light.
If 1-2-3-4-5-6-7-8 does not seem to work, please follow the steps
to perform a hard reset by following the procedure in on page 6.
3. Enter the code
009 #LL #
, where
LL
represents the length (number of
digits in a code). The range is from 04 to 08 digits.
You can leave the
factory default Access Code length (4 digits) if you wish by not
changing the length.
4. Example of Complete Entry:
009#05#
to change the code length to 5
digits.
5. Key in another
#
to indicate the end of programming.
6. From now on, all the Access Codes you create must be the length
specified in this step.
Summary of Contents for E-PLEX 50XX SERIES
Page 1: ...OPERATIONS MANUAL E PLEX 50XX 30XX SERIES...
Page 19: ...Notes Notes 19...
Page 20: ...20 Notes...
Page 21: ...21 Notes...
