8
2.
Enter the E-Plex 5000 factory Master (Programming) Code
(
#12345678#). The lock responds with a flashing green light. If
1-2-3-4-5-6-7-8 does not seem to work, please follow the steps
to perform a hard reset by following the procedure in on page 7.
3.
Enter the code
009 #LL #, where LL represents the length
(number of digits in a code). The range is from 04 to 08 digits.
You can leave the factory default Access Code length
(4 digits) if you wish.
4.
Example of Complete Entry:
009#04#.
5.
Key in another
# to indicate the end of programming.
6.
From now on, all the Access Codes you create must be the
length specified in this step.
Procedure 2 - Modify the Master User Access Code
Required User Level: Master
1.
To change the factory code or current Master Code, follow the
next three steps:
2.
Put lock into Pushbutton Programming Mode.
3.
Use the command,
000, for Master, then the new Master
Code number.
4.
You must use 8 digits between 00000000 and 99999999 as follows:
000#MMMMMMMM#, we’ll use 000#00004992# as an example.
5.
Enter the Master Code again
00004992# for confirmation.
6.
Example of Complete Entry:
000#00004992#00004992#.
7.
Key in another
# to indicate the end of programming.
8.
After that, you will always use your own Master Code. Please
write the code down and keep in a safe place. The factory
code is no longer valid.
Procedure 3 - Set the Date / Time
You must enter the current date and time in each lock to enable accurate
programming and auditing. Always enter Standard Time; the software
package will make the adjustment for Daylight Savings Time. These
must be regularly updated according to your maintenance schedule.
Enter
001 for date settings and 002 for time settings. Date / time settings
are kept after a battery change unless you remove the batteries for more
than two minutes. In this case, the time is reset to 00:00:00 and the
date to 01/01/00.
