10
8.
Example of Complete Entry:
004#10#.
9.
Enter another
# to indicate the end of programming.
10. You have now programmed the lock ID 1234 and, for example,
an Unlock Time of 10 seconds for the door.
Procedure 5 - Program the Duration of the Passage Mode
period
You might want to program locks for public areas, such as cafeterias, to
have free access (Passage Mode) during certain periods of the day, and
revert to required code access outside of these regular hours.
The length of time that the lock remains in Passage Mode is programmable.
The factory default length of time for Passage Mode is 9 hours - you may
leave the default.
Once the lock has been put into Passage Mode, it will automatically
relock after the designated duration.
Required User Level: Master, Manager
1.
Put the lock into Pushbutton Programming Mode.
2.
Enter command code
005#.
3.
Then
TT#, where TT= 01 to 24 hours.
4.
A TT entry of 00 means there is no time limit - the door
remains unlocked.
5.
Enter
005 #TT#; for example, 005#06# for six hours.
6.
Example of Complete Entry:
005#06#.
7.
Enter another
# to indicate the end of programming.
8.
In this example, the lock will remain unlocked for six hours,
starting from the time you put it in Passage Mode.
9.
You have now configured the duration of the Passage Mode
period for that lock. This does
NOT initiate Passage Mode.
10. The new length of time will take effect the next time you
put a lock into Passage Mode by following the correct
command sequence.
