Kaba E-PLEX 2000, Operation Manual

Page: 8 / 32

8
For example
• If the Master or Manager enters his code of 87654321 , the door will open.
• If he enters #87654321# , the lock will enter into the Programming Mode
and wait for the next part of the command.
• If he enters the # sign twice at the end of the code, for example
#87654321## , the lock will go out of Programming Mode and return to its
normal mode.
Note: The # pound sign acts like the Enter key on a keyboard in your commu-
nications with the lock. The # tells the lock that one part of the entry is fin-
ished. The # serves another purpose - to distinguish a programming type
command from a simple Access Code to open the door. A Master or Manager
User can use the same number to open the door or to put the lock in
Programming Mode, the only difference being that he uses the # sign in front
to signal that he is about to enter a programming command. For increased
security, it is recommended that the master user code not be used for every-
day access. This can be accomplished by creating an access user code for the
master user.
Reset Procedures
There are three different “Reset” levels available in the E-Plex 2000.
Code 099# will reset the lock to the factory default settings except for the
access code length (Master and Manager User codes are retained if already
programmed)
Code 299# will delete all access and service user codes (Master and
Manager users are retained)
Hard Reset will return the lock to factory mode including deleting all codes,
putting the lock back to factory default values (4 digit access code length) and
making the master code 1-2-3-4-5-6-7-8. A hard reset is performed as follows.
Resetting a Lock to Factory-Default: (lock must be powered)
• On the inside or back housing, remove the top right screw holding the lock to
the door.
• Insert a long non-metallic blunt ended tool in the screw hole to press and
release the Reset-to-Factory-Default button. You will hear the motor turning if
successful, meaning the lock has reset.