7
InsTallaTIon of The dIal rIng
1� Remove the two screws from the dial ring assembly cover and remove
the cover�
Note:
Make sure the tubes are projecting through the container as shown in Figure
9 on the previous page. If not, the tubes are not seated properly in the lock or they
were not cut to the proper length. Correct the problem before proceeding.
2� If necessary, rotate the tube retainer in the dial ring so the cables come through
the notch in the tube retainer� See Appendix A for details�
3� Feed the cables through the tube retainer on the dial ring and place the dial ring
over the end of the tubes� Make sure the tubes are seated in the tube retainer
on the dial ring�
4� Attach the dial ring to the container with the dial ring mounting screws and
tighten to the specified torque. (See Page 1.)
InsTallaTIon of The Cables
1� Open the ZIF (Zero Insertion Force) seal cover and move the ZIF connector
locking actuators outward to their open position� (See Figures 11 and 12�)
2� Plug the cables into the ZIF connectors with the bright metal tabs facing toward
the circuit board� Push the cables into the connectors as far as they will go�
3� Close the ZIF locking actuators to lock the cables in place�
4� Close the ZIF seal cover� When closing, be sure the tenons in the seal cover
align with the holes of the seal cover�
Seal Cover
ZIF Connectors
Closed
Open
figure 11 - open ZIf seal Cover
figure 12- Closed & open
ZIf Connectors
Summary of Contents for X-10
Page 1: ...INSTALLATION INSTRUCTIONS X 10TM Type 1F HIGH SECURITY ELECTRONIC LOCK...
Page 18: ...16 Notes...
Page 19: ...17 Notes...
