13
open and Close The X-10 (faCTory CombInaTIon)
CW=Clockwise; CCW=Counterclockwise
Note:
The viewing angle of the LCD is restricted from either side as a security
feature of the lock. This feature restricts viewing of combination dialing by the
casual observer.
To open The loCK (using the factory Combination):
1� Dial left (CCW) until lock is “powered”� The lock is considered “powered” when
numbers appear on the LCD display screen�
2. Continue dialing left (CCW) to the first number of the factory combination, 50.
Stop on 50 and pause briefly.
3� Dial right (CW) to the second number of the factory combination, 25� Stop on 25
and pause briefly.
4. Dial left (CCW) to the first number of the factory combination, 50. Stop on 50
and pause briefly.
5� Dial right (CW)� After OP with a right arrow (OPen right) is displayed, dial to the
right to retract the lock bolt�
Note:
If at any time the dial remains stationary for more than 40 seconds,
the lock will reset (LCD will go blank) requiring the operator to redial the
entire combination.
To Close The loCK:
1� Turn Dial to the left (CCW) a minimum of one complete revolution to extend
the bolt� Wait 3 seconds�
2� Turn Dial to the right (CW) a minimum of one complete revolution to ensure that
it is locked�
Note:
The Dial should turn freely in either direction without catching or binding
when the bolt is extended and the container is locked.
Summary of Contents for X-10
Page 1: ...INSTALLATION INSTRUCTIONS X 10TM Type 1F HIGH SECURITY ELECTRONIC LOCK...
Page 18: ...16 Notes...
Page 19: ...17 Notes...
