Kaba Mas X-10, Installation Instructions Manual

Page: 11 / 20

9
6� Depending on the thickness of the container, additional cable guides may be
necessary to ensure the cables are held in place� Some possible locations are
shown in Figure 15� Install additional guides as needed, and route the LCD and
generator cables through them to ensure the cables do not get routed through
the “KEEP CLEAR” area, over the Zebra connector, or near where the geared
end of the dial hub will project through the dial ring cover�
Caution:
See Appendix B for more detail on routing the cables.
InsTallaTIon of The dIal rIng CoVer
1. Align the dial ring cover with the dial ring so the generator will seat into the five
o’clock position and the four aligning lugs align with the corresponding slots in
the dial ring� (See Figures 15 and 16�)
2� Carefully slide the dial ring cover into the dial ring�
3� Hold the dial ring cover in place and tighten the two dial ring cover mounting
screws to the specified torque. (See Page 1.)
CuTTIng and InsTallIng The spIndle
1� Slide the spindle into the lock case� Note the square portion of the spindle
must be aligned with the square hole in the lock case� Insert spindle screw and
tighten�
2� Slide the dial hub onto the spindle, turning the hub slightly to align the generator
drive gear teeth�
3� Partially tighten one setscrew to hold the dial hub in place�
4. Mark the spindle flush to the dial hub. (See Figure 17.)
5� Loosen the setscrew and remove the hub�
Alternate Method: Instead of removing the hub, you may leave it on, using the hub
as a vise to hold the spindle while cutting.
figure 15 - Cable guide locators
figure 16 - dial ring Cover
Generator