background image

(P/N) 735.028 Rev M • 11/14 

© copyright 2006-2014 

Kaba Mas LLC

Page 5 of 8

4. Re-enter the Delay and Open Period values to confirm. 

ACTIVATE THE LOCK

To complete the activation of the lock and freeze the configuration, the Manager combination MUST 
be changed 
To change the Manager combination, follow the steps below: 
WARNING: 
Add all required Users and complete Setup Configuration before changing the Manager’s 
default combination from 5-5-5-5-5-5. Once the combination is changed, NO ADDITIONAL USERS 
can be added.

CAUTION: Always perform this operation with the door open! 

1. Enter the default Manager combination and hold down the last digit until unit double signals twice
  release and the LED stays on. 
2. 

PRESS 0

3. Enter your NEW combination, 
4. Re-enter your NEW combination to confirm. 
5.  The lock is now active and the configuration is frozen. 
6. Test lock operation several times before closing the door. 
NOTE: If default combinations are used, it is recommended that they be changed. New combination 
will not be accepted if it varies from the current combination by only one digit (+/-). When selecting 
a combination, do not use a birthday or other predictable information that could give correlation 
between the user and the combination. 

RESET THE LOCK

(Reset Box [P/N 6066] required.) 
To change the lock settings after the configuration is frozen, you must reset the lock. 
1. Remove battery. 
2. Hold down the 0 key for at least 10 seconds to discharge all internal capacitors. 
3. Connect Reset Box to BAT port on Lock. 
4. 

PRESS 1

If the lock opens, the factory reset is complete. If the lock does not open, disconnect the Reset Box 
and repeat steps 2 and 3. 
5. Disconnect Reset Box. 
The Lock is now in Factory mode, and is ready to be configured by the PC Software or through 
the keypad.

Summary of Contents for LA GARD COMBOGARDPRO 39E









Reviews: