W W W . K A A R T A . C O M
1 4
Figure 13: Upper Vehicle Mount Assembly hardware re-installation.
S t e p 2 : S t o w t h e V e h i c l e M o u n t B a s e A s s e m b l y
1.
Using a 4mm hex allen key, loosen all sixteen (16) M6 x 16mm long button head
fasteners securing the four (4) Base Reinforcement plates to the Vehicle Mount
Base Assembly. Loosen fasteners just enough to so that the Base Reinforcement
Plates can slide along the side rails (approximately 1 full turn of the fastener).
Do
not remove the button head fasteners completely
. See Figure 14.
Figure 14: Vehicle Mount Base Assembly loosen base reinforcements.
VEHICLE MOUNT BASE ASSEMBLY
M8 HARDWARE
M8 HARDWARE
M6 X 16MM LONG BUTTON HEAD
FASTENEER (16X)
BASE REINFORCEMENT
