16
2�3�12 Installing the PXIe-63975
1 Locate the system controller slot (Slot 1)
2 Depress the red locking lever and release the latch
3 Align the controller’s top and bottom edges with the card guides, and carefully slide
the PXIe-63975 into the chassis, as shown
4 Elevate the latch until the PXIe-63975 is fully seated in the chassis backplane.
5 Fasten the four mounting screws on the faceplate of PXIe-63975, and connect all
peripheral devices.
2�3�13 Replacing the Hard Drive
The PXIe-63975 provides a SATA 2.0 port with a pre-installed 2.5” SATA hard drive.
Alternatively, a 2.5” solid state disk (SSD) can be used for shock/vibration resistance. This
section explains procedures for replacing the HDD.
1. Locate the four screws attaching the hard drive to the bracket on the rear of the PXIe-
63975 controller.
2. Remove the screws, as shown.
