35
5-1
Troubleshooting
Before requesting service for the DVD Recorder, check the chart below for a possible cause of the problem you are
experiencing. Some simple checkups or a minor adjustment on your part may eliminate the problem and restore proper
operation.
SYMPTOM (COMMON)
REMEDY
No power.
•
Insert the power plug securely into the power outlet.
•
Check if the ON/OFF button on the front of the player is set to on.
•
Check if no power at the AC outlet by plugging in another appliance for a test.
The player does not start playback when
•
Condensation has formed: wait about 1 to 2 hours to allow the player to dry out.
PLAY is pressed.
•
This player cannot play discs other than DVDs and audio CDs.
•
Check if the disc is defective by trying another disc.
•
Check the region (local) code.
The player starts playback but stops
•
The disc may be dirty and may require cleaning.
immediately.
•
Ensure that the disc is installed with the label side up.
No picture.
•
Ensure that the equipment is connected properly.
•
Ensure that the input setting for the TV is “Video”.
•
Check if the TV is on.
•
Select the same channel and source on the TV as on the player.
No sound.
•
Ensure that the equipment is connected properly.
•
If using a HiFi amplifier, try another sound source.
•
Check the Audio Output Setting menu to make sure that Analog Output is selected.
Distorted sound.
•
Ensure that the input settings for the TV and stereo system are proper.
•
No sound is heard during still picture (pause) or slow-motion playback.
No audio at Digital Output.
•
Check the digital connections.
•
Check the settings menu to make sure that the digital output is set to on.
•
Check if the audio format of the selected audio language matches your receiver capabilities.
Distorted picture.
•
Check the disc for fingerprints and clean with a soft cloth, wiping from center to edge.
•
Sometimes a small amount of picture distortion may appear. This is not a malfunction.
Completely distorted picture or no color in
•
The disc format is not according to the TV-set used (PAL/NTSC).
picture.
Picture is distorted during rapid advance or
•
The picture will be somewhat distorted at times: this is normal.
rapid reverse.
No rapid advance (or rapid reverse) playback.
•
Some discs may have sections which prohibit rapid advance (or rapid reverse).
No 4:3 (16:9) picture.
•
Choose the correct setup “Aspect Ratio” item which matches the TV set used.
No operations perform with the remote
•
Check the batteries are installed with the correct polarities (+ and –).
control.
•
The batteries are depleted: replace them with new ones.
•
Point the remote control unit at the remote control signal sensor and operate.
•
Operate the remote control unit at a distance of not more than 7 meters from the remote control signal sensor.
•
Remove the obstacles between the remote control unit and remote control signal sensor.
5 For
Y
our Reference
