13
Connecting an external control unit
When connecting the external control unit to the MAKE terminal, you can operate the following functions through the
MAKE terminal;
• Turn on or off the Monitor.
Preparation: The POWER switch on the rear must be set to “
|
(on)” (so that the Monitor is in standby mode).
• Select the input.
Preparation: “REMOTE SWITCH” should be set correctly to select your desired input (see page 27).
Notes:
• There is no remote control on/off switch. When a plug is inserted to the MAKE terminal, remote control through the
external control unit is automatically activated.
• When the other REMOTE terminals are used at the same time, transmitted commands through the MAKE terminal have
priority over those through the other terminals.
IMPORTANT:
External control unit is not commercially available in the market. When you need it, consult your dealer.
• MAKE terminal
• External control unit
Pin number
Signal name
1
GND
2
GND
3
SW2
4
SW1
5
SW DET
6
GND
Signals
transmitted
=
○
○
○
○
=
○
○
○
○
=
○
○
○
○
TTL level
H: Power Off
L: Power On
H: Input A*
L: Input B*
H: Not connected
L: Connected
* Input A and Input B will be determined by the “REMOTE
SWITCH” setting.
1
2
3
4
6
5
04-13_VM-4200.p65
03.7.23, 9:29 AM
13
