1-5
TH-A30
Remove the four screws A attaching the top cover
on both sides of the body.
Remove the three screws B on back of the body.
Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
1.
2.
3.
Disassembly method
Removing the top cover (See Fig.1)
Prior to performing the following procedure, remove
the top cover.
Remove the three screws C attaching the front panel
assembly on bottom of the body.
Remove the two screws D attaching the front panel
assembly on both sides of the body.
Remove the claw1, claw2 and claw3, and detach the
front panel assembly toward the front.
Disconnect the card wire from the connector FCW1
and FCW2 on the display board.
1.
2.
3.
4.
Removing the front panel assembly
(See Fig.2A, 2B and 3)
Prior to performing the following procedure, remove
the top cover.
Cut off the tie band fixing the power cord.
Disconnect the power cord from the connector
ACW1 on the main board and pull up the cord
stopper upward.
Notes : The power cord is exchangeable.
1.
2.
Removing the power cord (See Fig.4)
D
(both sides)
Claw2
(both sides)
Fig.1
Fig.2A
Fig.2B
Fig.3
Fig.4
A
(both sides)
B
Top cover
C
C
Claw1
Power cord
stopper
Power cord
Front panel assembly
(bottom side)
Front panel assembly
Front panel assembly
(Inner side)
Rear panel
Claw3
Display board
FCW1
FCW2
ACW1
Tie band
Summary of Contents for TH-A30
