Type
:
2-way 3-speaker bass-reflex type
Magnetically-shielded type
Speaker unit
Mid and low range
: 10.5 cm wooden cone x 2
Tweeter
: 2.0 cm wooden dome x 1
Frequency range
: 150 W
Impedance
: 6
K
Crossover frequency
: 3.8 kHz
Frequency range
: 45 Hz to 50 000 Hz
Sound pressure level
: 85 dB/W•m
Dimensions (WxHxD)
: 270 mm x 1101 mm x 320 mm
Mass
: 16 k
g
Supplied accessories
: Speaker cord (3 m) (1)
Foot (3)
Base (1)
Screw (3)
Design and specifications subject to change without notice.
Connection
Precautions
Before connecting:
Turn off the power to the amplifier before connecting the speaker
system; otherwise, the speakers may be damaged.
The impedance of the speaker is 6
K
.
If this does not match with the speaker impedance range
indicated on the amplifier, you cannot connect this system to the
amplifier.
The maximum power handling capacity of the SX-WD10 is 150
W. Excessive input will result in abnormal noise and possible
damage.
Be sure to turn down the volume level on the amplifier to prevent
unwanted noise before performing following operations:
Turning on or off other components
Operating the amplifier
Tuning FM stations
Fast-forwarding a tape
Continuously reproducing high frequency oscillation or high
pitch electronic sounds
Connecting or disconnecting a microphone
When using a microphone, do not aim it at the speakers or use
it near the speakers; otherwise, the howling which occurs may
damage the speakers.
Before replacing the cartridge, always turn off the power both to
the amplifier and to the turntable; otherwise, the clicking noise
may damage the speakers.
Connecting the speaker system to the amplifier
Twist and remove the insulation at the end of each
speaker cord before connecting.
•
G
terminal
(Black hoop)
F
terminal
(Red hoop)
Silver
Copper
To the speaker
F
terminal of amplifier
To the speaker
G
terminal of amplifier
Make sure to match the polarity (
F
and
G
); otherwise, the
surround effect will become less effective.
o
•
•
•
•
–
–
–
–
–
–
•
•
o
•
To remove the speaker grille
To remove the speaker grille,
insert your fingers at the bottom of
the speaker grille, then pull upward.
To attach the speaker grille,
put the projections of the speaker
into the holes of the speaker grille.
Do not press the speaker grille strongly.
o
•
About Speaker Grille
Specifications
4
English
SX-WD10_Book.indb 5
10/5/2005 AM 10:01:54
