EN
63
This Remote is capable of transmitting two control
codes; one set to respond to A code control signals and
another set to respond to B code control signals.
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily modify your VCR and the Remote
to respond to B code signals.
When using two JVC VCRs, set two VCRs and their
Remotes to different codes, so that you can operate these
VCRs separately.
1
Set remote operation mode
Set the
VCR/TV/CABLE/DBS
selector to “VCR”.
2
Set remote control code for Remote
1
Press and hold
A/B
.
2
Press the
Number
key “
2
”.
3
Press
STOP
(
7
), and release
A/B
.
3
Turn off VCR
Press
POWER
on the VCR.
4
Check remote control code for VCR
Press
PLAY
(
3
) on the VCR for more than 5
seconds.
●
The code currently set appears on the front
display panel.
5
Turn on VCR
Press
POWER
on the Remote.
●
The code transmitted from the Remote blinks
for a few seconds on the front display panel.
●
After the code disappears on the front display
panel, make sure that the VCR is turned on by
pressing
POWER
on the Remote.
●
To set the Remote and the VCR back to A code
control signals, repeat the same procedure as
shown above except pressing the
Number
key
“
1
” in step
2
.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote
control code for the Remote between A and B
(
step
2
), keeping two VCRs to different control codes.
●
Press the
Number
key “
1
” for A code control signals
and the
Number
key “
2
” for B code control signals. (To
change only the remote control code for the Remote,
DO NOT perform steps
3
to
5
.)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
Press in succession
Hold
down
Release
STOP
ABC
A/B
2
1
2
3
4
5
6
7
8
9
0
VCR TV CABLE/DBS
2
–
1
,
3
5
2
2
–
3
2
–
2
NOTE:
When "POWER SAVE MODE" is set to "ON" , you can not
change the remote control code. Before changing the code, set
"POWER SAVE MODE" to "OFF" (
pg. 52).
VDA300U-EN56-63
03.7.18, 12:16 PM
63
