1-3
RX-E112RSL/RX-E111RSL
Remove the four screws A attaching the top cover on
both sides of the body.
Remove the three screws B on the back of the body.
Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
1.
2.
3.
Disassembly method
Removing the top cover (See Fig.1)
Prior to performing the following procedure, remove
the top cover.
Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
Remove the nineteen screws F & G attaching the
each boards to the rear panel.
Remove the four screws H attaching the rear panel
on the back of the body.
1.
2.
3.
Removing the rear panel (See Fig.4)
Prior to performing the following procedure, remove
the top cover.
Cut off the tie band fixing the harness, if needed.
Disconnect the card wire from the connector CN411
on the audio board, CN412 on the input board and
CN204 on the power supply board.
Disconnect the harness form the connector CN209
on the power supply board.
Remove the three screws C attaching the front
panel assembly.
Remove the screw D attaching the headphone jack
board.
Remove the four screws E attaching the front panel
assembly on the bottom of the body. Detach the front
panel assembly toward the front.
1.
2.
3.
4.
5.
6.
Removing the front panel assembly
(See Fig.2 and 3)
Fig.1
Fig.2
Fig.3
Fig.4
A
(both sides)
B
Top cover
C
C
Power supply
board
Audio board
CN411
Main board
Tie band
G
F
F
F
H
H
H
H
Power cord
stopper
Front panel assembly
Front panel assembly
(Bottom side)
D
(attaching the
headphone jack board)
Rear panel
CN204
CN209
E
CN412
Input board
E
