JVC RX-DP15B - AV Receiver Page 166 Instructions Manual Download

Page: 166 / 178

English

Operating Video Components

IMPORTANT:

To operate JVC’s video components using this remote control:

• You need to connect JVC’s video components through the AV

COMPU LINK jacks (see page 68) in addition to the connections
using cables with RCA pin plugs (see pages 13 to 15).

• Some JVC VCRs can accept two types of control signals—remote

codes “A” and “B.” Before using this remote control, make sure that
the remote control code of the VCR connected to the VCR 1 IN
jacks is set to code “A.”
– When another JVC VCR is connected to the VCR 2 IN and VIDEO

jacks, set its remote control code to code “B.” (This remote control
cannot emit the control signals of code “B.”)

• To operate the video component(s) using the remote control:

– Aim the remote control directly at the remote sensor on each

component, not on the receiver.

• To operate the video component(s) using the RF signals emitted

from this remote control, the IR signal transmitter and the RF rod
antenna must be connected to this receiver.
– Place the IR signal transmitter so that it is aimed at the remote

sensor(s) on the target video component(s).

– The RF signal-reachable distance may differ depending on the

operating conditions and circumstances.

– The IR signal transmitter can send signals from a distance of 3 m.

When using the remote control:

– Set the ZONE 1/ZONE 2 (LEARN/TRANSMIT) selector to

“ZONE 1”

“ZONE 2”

correctly.

– Set the TV operation mode selector to

“TV”

“CATV/DBS”

properly.

To operate TV, set it to “TV.”

– Check the indication shown on the remote’s display

when you press a button—this indicates the remote
control operation mode together with multi-room operation mode
(either ZONE 1 or ZONE 2) for a while.

– The CONTROL button can change the remote control operation

mode without changing the source.
Each time you press the button, the remote control operation mode
changes in the sequence—VCR1

TAPE

CDR

CD DISC

(back

to the beginning).

CATV/

DBS

ZONE 2

TRANSMIT

LEARN

ZONE 1

VCR (VCR connected to the VCR 1 jacks)

You can always perform the following operations:

VCR 1

(STANDBY/ON)

: Turns on or off the VCR.

After pressing VCR 1 or selecting “VCR1” by pressing CONTROL
repeatedly, you can perform the following operations on the VCR:

1 – 9, 0

: Selects the TV channels on the VCR.

PLAY

: Starts playing.

REW

: Rewinds a tape.

: Fast-winds a tape.

STOP

: Stops operations.

PAUSE

: Pauses playing. To release, press PLAY.

REC

: Press this button together with the PLAY button

to start recording (only for Zone 1 operations).
Press this button together with the PAUSE button
to enter recording pause (only for Zone 1
operations).

C/–

: Changes the TV channels on the VCR.

DVD player

After pressing DVD (or DVD MULTI: only for Zone 1 operations),
you can perform the following operations on the DVD player:

1 – 10, 0, +10

: Selects the DVD titles or the chapters.

PLAY

: Starts playing.

: Returns to the beginning of the current (or

previous) chapter.

: Skips to the beginning of the next chapter.

STOP