Page 48
English
After several seconds, the SEND/LEARN indicator goes off and lights up again. This means that the
storing is successfully finished.
Notes:
• If the SEND/LEARN indicator stops flashing before you press the button on the target remote control,
repeat from step 5 again.
• If the ERROR indicator lights red and does not go off, you have failed in storing the signal.
• If the ERROR indicator flashes, you have failed in storing the signal. Try again. However some signals
do not match to this remote control even though this remote control can lean most infrared signals.
7
Repeat steps 5 to 6 to store more signals in the same remote mode.
Repeat steps 4 to 6 to store more signals in a different remote mode.
8
Press LEARN to finish the storing procedure.
Note:
The signals stored into this remote control from the target remote control deviates slightly from the
original signals. Since some components will not accept these deviating signals, you may not be able to
operate those components using this remote control even though the storing procedure has been
successfully finished.
CAUTION:
When replacing the batteries, finish it without delay; otherwise, the stored signals are all erased.
Using stored signals
When you want to use the stored signals, follow the procedure below.
1
Open the outside panel of the remote control.
2
Press one of the remote mode buttons.
3
Press the desired button.
Note:
When you have stored signals into the TV and VCR buttons, simply pressing the button will send the stored
signals. You do not have to press a remote mode button.
Remote: Outside
SEND/LEARN
ERROR
SEND/LEARN
ERROR
Lights
SEND/LEARN
ERROR
Remote: Inside
CANCEL
LEARN
TV
VCR
Remote: Inside
4
3
2
7/P
6
0
10
+10
8
1
5
9
PRESET
CHANNEL
TEST
TV
VOLUME
DELAY
+
–
CENTER
+
–
REAR
TV/VIDEO
PTY SELECT
PTY SEARCH
PTY SELECT
DISPLAY MODE
+
–
FM
MODE/MUTE
TAPE
TAPE
CD
VCR
TV
EXT.1
EXT.2
RX-730RBK(EF)0054-001A.En.42-52
97.7.25, 7:07 PM
48
