12
English
On the front panel:
1. Press SETTING so that the cursor
control
%
/
fi
buttons work for
setting the delay time.
2. Press cursor control
%
/
fi
repeatedly until “DELAY TIME”
appears on the display.
3. Press cursor control
@
/
#
to
select an appropriate delay time.
As the distance from you to your rear speakers decreases, you
will get the better surround sound by using the smaller delay
time.
From the remote control:
1. Press SOUND CONTROL.
2. Press SURROUND repeatedly until “PRO LOGIC” appears on
the display.
3. Press DELAY repeatedly until an appropriate delay time appears
on the display.
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the
receiver will turn off by itself rather than play all night.
From the remote control ONLY:
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display,
and the shut-off time changes as follows (in
minutes):
When the shut-off time comes
The receiver turns off automatically.
To check or change the time remaining until the
shut-off time
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 00min.” appears on the
display. (The SLEEP indicator goes off.)
Turning off the power also cancels the Sleep Timer.
SETTING
DELAY 15msec
DELAY 20msec
DELAY 30msec
SLEEP
20
10
30
40
50
60
70
80
90
(Canceled)
00
Storing the Basic Settings and
Adjustments — One Touch Operation
JVC’s One Touch Operation function is used to assign and store
different sound settings for each different playing source. By using
this function, you don’t have to change the settings every time you
change the source. The stored settings for the newly selected source
are automatically recalled.
The following can be stored for each source:
• Volume level (see page 9)
• Input Attenuator (see page 10)
• Balance (see page 10)
• Bass Boost (see page 10)
• Tone adjustment (see page 10)
• DSP modes
– 3D-PHONIC mode settings (see page 19)
– DAP mode settings (see page 19)
– Surround mode settings (see page 20)
• DVD MULTI playback mode settings (see page 22)
To store the sound settings
1. Press ONE TOUCH OPERATION.
The ONE TOUCH OPERATION lamp lights up, then the
previously memorized settings are recalled.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings for the
currently selected source are recalled, when the source is selected.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes off.
(Even though the One Touch Operation function is canceled, the
recalled sound effects remain active.)
Notes:
• If the source is FM or AM (MW/LW), you can assign a different
setting for each band.
• The DSP modes and DVD MULTI playback mode cannot be used
at the same time.
ONE TOUCH OPERATION
ONE TOUCH
OPERATION
On the front panel
On the remote
EN08_22.RX-668R[E]/2
99.1.28, 1:13 PM
12
