NX-CDR7R
1-23
Prior to performing the following procedures, remove
the servo control board, the top cover, the tray unit,
the side unit (L) and the side unit (R).
Turn the hook gear counterclockwise to move the
slide hook and the slider (R) backward until they
stop.
Slide the slide cam (L) and the slide cam (R) in the
direction of the arrow until they stop.
(The notches of each slide cam are fitted to the pins
on both sides of the sub chassis unit.)
Detach the sub chassis unit upward.
1.
2.
3.
Removing the sub chassis unit
(See Fig.10 to 12)
When reassembling, turn the hook gear
of the chassis unit counterclockwise until
it stops and slide the slide hook and the
slider (R) of the sub chassis unit
backward until they stop.
ATTENTION:
Fig.10
Fig.11
Fig.12
Slide cam (L)
Slide cam (R)
Sub chassis unit
Sub chassis unit
Pin
Pin
Slide cam (L)
Slider (R)
Hook gear
slide hook
Notch
Summary of Contents for NX-CDR7R
