JVC NX-CDR7R, Service Manual

Page: 17 / 88

NX-CDR7R
1-17
Remove the four screws S on the back of the front
panel assembly. 1.
<Front panel assembly section>
Removing the LCD board (See Fig.36)
Remove the seven screws T.
Disconnect the card wire from connector CN671 and
CN672 on the function switch board.
1.
2.
Removing the function switch board
(See Fig.37)
Remove the screw U attaching the presser board of
the phone jack board.
Remove the screw V attaching the earth terminal
extending from the phone jack board.
1.
2.
Removing the phone jack board
(See Fig.38)
Disconnect the wire from connector CN582 on the
OPEN / CLOSE SW detect board.
Disconnect the wire from connector CN583 on the
motor board.
Remove the screw W.
1.
2.
3.
Removing the motor board (See Fig.39)
Disconnect the wire from connector CN582 on the
OPEN / CLOSE SW detect board.
Remove the two screws X.
1.
2.
Removing the OPEN / CLOSE SW detect
board (See Fig.39)
When reconnecting each card wire, let it
through the three notches m of the as
shown in Fig.37. CAUTION:
Prior to performing the following procedures, remove
the metal cover and the front panel assembly.
Fig.36
Fig.37
Fig.38
Fig.39
S
S
LCD board
Function switch
board
Motor board
Phone jack board
Notches m
T T
Function switch board
V
U
Presser board
Phone jack board
X
OPEN / CLOSE SW detect board
CN582
Motor board
CN583
W