JVC LVT2099-029A, Instructions Manual

Page: 23 / 48

23
Installation and
Setup
[LANGUAGE] Menu
Display Menu
Select a language for the [Setup] menu and on-
screen display.
Disc Menu / Disc Audio / Disc Subtitle
Select the language you prefer for the audio track
(disc audio), subtitles, and the disc menu.
[Original] – Refers to the original language in
which the disc was recorded.
[Other] – Press ENTER to select another
language. Use number buttons then ENTER to
enter the corresponding 4-digit number
according to the language code list on page 42.
[Off] (for Disc Subtitle) – Turn off Subtitle.
Note:
Depending upon the disc, your language setting
may not work for some discs.
[AUDIO] Menu
Speaker Setup
To obtain the best possible sound, use the Speaker
Setup display to specify the volume of the speakers
you have connected and their distance from your lis-
tening position. Use the Test to adjust the volume of
the speakers to the same level.
[Speaker] – Select a speaker that you want to
adjust.
[Volume] – Adjust the output level of each
speaker. Be sure to set “Test” to “All” for easy
adjustment.
[Distance] – Adjust the distance between each
speaker and the listening position.
[Test] – The speakers will emit a test tone.
All: The test tone is emitted from each speaker in
sequence.
To save your settings, press ENTER and select
[Yes] by pressing
b b
/
B B
.
HD AV Sync
Sometimes Digital TV encounters a delay between
picture and sound. If this happens you can compen-
sate by setting a delay on the sound so that it
effectively ‘waits’ for the picture to arrive: this is called
HD AV Sync.
Use
v V
to scroll up and down through the delay
amount, which you can set at anything between 0 and
300m sec.
The delay will vary depending on which digital TV
channel you are on. If you change channel you may
need to readjust the HD AV Sync.
HDMI Audio
You can set TV speaker output for the audio signal
from the HDMI OUT jack.
[Off] – Audio signals are output to the system
speakers only.
[On] – Audio signals are output from the TV’s
speaker and the system’s front left and right
speakers and subwoofer.
Note:
When [HDMI Audio] is set to [On], the sound mode
is switched to [BYPASS] automatically.