JVC LT-32C600 Instruction Manual Download Page 7

Page: 7 / 68

2 Preparation

Unpacking the TV

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.

The following items are included:

Thank you

for purchasing your new JVC TV.

Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.

Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Chapter

Stand screws x2

Instruction Manual

Quick Start Guide

Instruction Manual

32" LED Smart HD TV

LT-32C600

Quick Start Guide

32" LED Smart HD TV

LT-32C600

Thank you

for purchasing your new JVC TV.

Your new TV incorporates the latest technology to enhance your viewing

experience. We would suggest that you allow about 15 mins for initial setup.
Please follow this guide for a successful first time installation.

The latest eco-friendly power-saving technology will switch off the TV if

it is left on and idle for 4 hours. Please refer to “Auto Standby” under the

“Time Settings” section of the instruction manual for more detail.

What’s in the Box?

Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.

TV
TV Stand x 2

Remote Control/

AAA Batteries x2

  Stand Screws x 2
  Instruction Manual
  Quick Start Guide

Please inspect your TV for damage after unpacking. If

you do notice any damage please consult your dealer.

Operating Your Remote Control

1. Slide open the battery compartment on the back of the remote control.

2. Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of

the batteries with the (+) and ( - ) ends indicated in the battery compartment.

3. Slide the battery compartment cover back into place. Make sure it clicks into place.

For extra safety use the screw supplied to screw the battery compartment closed.

Fitting the Stand to the TV

1. Ensure the TV is switched off and not connected to the mains power supply.

2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table, with the back side facing up.

Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is placed beneath the screen.

3. Fit each leg to your TV using the screws supplied.

For wall mounting instructions please refer to your Instruction Book.

Installing the Base Stand

The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object, or

anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because the

screen could crack.

•  Do not connect the TV to the mains supply until you have completed all the connections.
•  Always disconnect the TV from the mains socket when not in use for a long period of time.
•  The   button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.

To completely disconnect the mains power, please remove the mains plug from the mains socket.

1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on the back of your TV.

2. Plug the TV into a mains socket and switch on at the mains.

3. In standby mode, press the button on the remote control to turn the TV on. The LED indicator will flash for a few seconds then the TV will switch on.

Connecting the Aerial and Turning on the TV

SPDIF

Optic.OUT

VGA

ANT

HDMI 2

(ARC

)

LAN

AV IN

SPDIF

Optic.OUT