JVC KV-MR9000, Service Manual

Page: 11 / 45

(No.49785)1-11
3.3.2 Removing the monitor board
(See Fig.17)
• Prior to performing the following procedure, remove the bottom
cover.
(1) Disconnect the connectors B1 , B2 and CON2 on the mon-
itor board.
(2) Disconnect the connector M1 , B3 and W1 on the monitor
board.
(3) Remove the solder from the ground wire f on the back of
panel.
(4) Remove the four screws P attaching the monitor board.
Fig.17
3.3.3 Removing the panel
(See Fig.18)
• Prior to performing the following procedure, remove the bottom
cover.
(1) Remove the three screws Q attaching the lcd bracket on
the top coverr.
(2) Remove the screw R attaching the panel.
(3) Remove the two screws S attaching the lcd bracket on the
top cover.
(4) Release the PC shield plate from flexible wire h , flexible
wire j .
CAUTION:
Be careful when release the PC shield plate do not damage
flexible wires.(See Fig.18)
Fig.18
3.3.4 Removing the mico switch bracket
(See Fig.19)
• Prior to performing the following procedure, remove the bottom
cover.
(1) Disconnect the connector W1 on the monitor board.
(2) Remove the two screws T attaching the mico switch brack-
et on the top cover.
Fig.19
Ground wire f
Monitor board Tape g
M1 B3 CON2
B1
W1
B2
P P
Panel
LCD bracket
LCD
bracket
PC shield plate
Flexible wire h
Flexible wire j
S
R
Q
Monitor
board
Mico switch bracket
W1
T