JVC KV-MR9000, Service Manual

Page: 6 / 45

1-6 (No.49785)
3.1.2 Removing the monitor unit
(See Figs.3 to 5)
• Prior to performing the following procedure, remove the base
cover aseembly.
(1) Release the four claws b attaching the shaft cover.
(2) Remove the four screws B attaching the hinge on the base
cover aseembly.
(3) Remove the two screws C attaching the connect board on
the back of the base cover aseembly.
(4) Disconnect the two connectors B1 and B2 on the connect
board.
REFERENCE:
Reassembly of the monitor unit section
Before attaching the monitor unit, put the flexible wire through
the hole
c of the base cover aseembly. (See Fig.3)
3.1.3 Removing the connect board
(See Fig.5)
• Prior to performing the following procedure, remove the base
cover aseembly.
(1) Remove the two screws C attaching the connect board on
the base cover aseembly.
(2) Disconnect the two connectors B1 , B2 , CON1 and CON2
on the connect board.
Fig.3
Fig.4
Fig.5
Base cover assembly
Cover shaft Cover shaft
Claw b Claw b
Hole c
B B
CON1
CON2
Connect board
C
B2
B1