ENGLISH
13
Pair and connect a Bluetooth device for the first time
1
Press source button to turn on the unit.
2
Search and select the name of your receiver (“KD-T9
BT”) on the Bluetooth device.
“BT PAIRING” flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
3
Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) KD-T902BT:
“Device
Name”
“XXXXXX” “VOL – YES” “BACK – NO”
KD-T901BT:
“Device
Name”
“XXXXXX” “ENTER – YES” “BACK – NO”
“XXXXXX” is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the following to confirm the passkey.
KD-T902BT: Volume knob
KD-T901BT:
*
ENTER
Operate the Bluetooth device to confirm the passkey.
(B) KD-T902BT:
“Device
Name”
“VOL – YES” “BACK – NO”
KD-T901BT:
“Device
Name”
“ENTER – YES” “BACK – NO”
Press the following to start pairing.
KD-T902BT: Volume knob
KD-T901BT:
*
ENTER
• If
“PAIRING” “PIN 0000” scrolls on the display, enter the PIN code “0000” into the
Bluetooth
device.
You can change to a desired PIN code before pairing. (Page 18)
• If only “PAIRING” appears, operate the Bluetooth device to confirm pairing.
“PAIRING COMPLETED” appears when pairing is completed and “
O
” will light up when the Bluetooth
connection is established. The battery and signal strength of the connected Bluetooth device is
shown (see
[FORMAT]
on page 28).
BLUETOOTH®
Depending on the operating system and the
firmware version of your mobile phone, Bluetooth
features may not work with this unit.
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Adjust the microphone
angle
Secure using cord clamps (not
supplied) if necessary.
Microphone input jack
Microphone (supplied)
Rear panel
