Https://www.bueno-electric.com
BUENO ELECTRIC
BUENO ELECTRIC
BUENO ELECTRIC
BUENO ELECTRIC
Contact: [email protected]
Fax: +86-25-51816989
31
2.2.5.3 Setting switchover
Select the submenu “setting switchover” under the menu “operation setup” or press the
“setting switchover” key, a setting change window will be seen directly.
Setting switchover
Select setting zone : 00±
Current operating zone : 01
Use “+” or “
－
” key to select setting area you want to change (also it can be done by the
setting switchover keys). If you want to give up the switchover, just press “Q” key. press
【
←┘
】
key to start the switchover. The system asks you entering the secret code. The process is the same
as the pressure plate switchover and will not be repeated here.
Several setting zone are provided for storage. Before operating a setting switchover, care
must be taken that the zone you want to switch over must have its settings otherwise you cannot
make any switch. By using the command “setting alteration” you can write several sets of setting
into the zone and then make switchover..
2.2.5.4 Setting printing
In the setting print menu, MMI will first ask you to select setting zone. Press “+” and “
－
”
keys to select the number of the setting zone to be printed. Press
【
←┘
】
key to make the setting
printing.
Setting printing
Select setting zone : 00±
Current operating zone : 01
Setting zone selection
Use “
∧
” or “
∨
” key to turn the lines, “+” or “
－
” key to turn the pages .
2.2.6 System setup
2.2.6.1 Pressure plate setup
Select submenu “pressure plate setup” under menu “system setup”, the window will show :
Pressure plate setup
Overcurrent zone I on
Overcurrent zone II on
Overcurrent zone III off
