16
ENGLISH
Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory
(USER 1, USER 2 and USER 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press EQ.
The last selected sound mode
is recalled, and it is applied to
the current source.
2
Press SEL (select) to select sound
elements to adjust.
Each time you press the
button, the sound elements
to adjust change as follows:
LOW FREQ.*
=
LOW WIDTH
=
LOW LEVEL
=
MID FREQ.*
=
MID WIDTH
=
MID LEVEL
=
HIGH FREQ.*
=
HIGH LEVEL
=
(back to the beginning)
FREQ. (LOW, MID, HIGH)
:
Select the center frequency to adjust.
WIDTH (LOW, MID)
:
Select the band width level (Q).
LEVEL (LOW, MID, HIGH)
:
Adjust the enhancement level.
*
By pressing
¢
or
4
, you
can directly move as follows:
3
Adjust the selected sound element.
• Refer to the table below for adjusting the
selected sound element.
Ex.: When you have selected “POP” previously
4
Repeat steps 2 and 3 to adjust the
other sound elements.
5
Select one of the user sound modes
(USER 1, USER 2, USER 3).
6
Press EQ to store the adjustments.
To reset to the factory settings
Repeat the same procedure and reassign the
preset values listed in the table on page 28.
Preset values
LOW
MID
HIGH
50 Hz
700 Hz
8 kHz
80 Hz
1 kHz
12 kHz
120 Hz
2 kHz
1 (min.)
1 (min.)
|
|
4 (max.)
2 (max.)
–06 (min.)
–06 (min.)
–06 (min.)
|
|
|
+06 (max.) +06 (max.) +06 (max.)
Indication
FREQ.
WIDTH
LEVEL
Ex.: When you select “USER 2”
LOW FREQ.
MID FREQ.
HIGH FREQ.
EN14-16.KD-SH77_55[J]f
01.1.9, 4:32 PM
16
