JVC KD-S871R, Service Manual

Page: 9 / 50

1-9
KD-S871R
Unsolder the part a and b on the CD mechanism
control board.
Remove the stator fixing the CD mechanism control
board and the damper bracket (To remove the stator
smoothly, pick up the center part).
Remove the screw A attaching the CD mechanism
control board.
Remove the CD mechanism control board in the
direction of the arrow while releasing it from the two
damper bracket slots d and the front bracket slot e.
Disconnect the flexible wire from connector on the
pickup unit.
1.
2.
3.
4.
5.
Removing the CD mechanism control
board (See Fig.1 and 2)
Turn the FD gear in the direction of the
arrow to move the entire pickup unit to
the appropriate position where the
flexible wire of the CD mechanism unit
can be disconnected easily.
(Refer to Fig.2)
ATTENTION:
Prior to performing the following procedure, remove
the CD mechanism control board.
Remove the two springs f attaching the CD
mechanism assembly and the front bracket.
Remove the two screws B and the front bracket
while pulling the flame outward.
Remove the belt and the screw C from the loading
motor.
1.
2.
3.
Removing the loading motor
(See Fig.3 to 5)
<CD mechanism section>
Fig.2
Fig.3
Fig.4
Shift the lock
Flexible wire
Pickup unit
FD gear
CD mechanism control board
Loading motor
Front bracket
Front bracket
Pull outward
Pull outward
Flame
f
B
f
B
Fig.5
C
Loading motor
Belt
Fig.1
Front bracket
CD mechanism
control board
Damper bracket
h
c
d
b
a
D
D
D
CD mechanism assembly
A
e
h