- 2 -
For your safety
This equipment has been designed and manufactured to meet international safety stan-
dards but, like any electrical equipment, care must be taken if you are to obtain the best re-
sults and safety is to be assured. So, please read the points below for your own safety. They
are of a general nature, intended to help you with all your electronic consumer products and
some points may not apply to the goods you have just purchased.
Some DOs and DONTs for you
Air Circulation
Leave at least 10cm clearance around the television to allow adequate ventilation. This will
prevent the TV from overheating and consequential possible damage to the TV. Dusty places
should also be avoided.
Heat Damage
Damage may occur if you leave the TV in direct sunlight or near a heater. Avoid places sub-
ject to extremely high temperatures or humidity, or locations where the temperature is likely
to fall below 5ºC (41ºF).
Mains Supply
The mains supply required for this equipment is
100 -240 AC
, 50 Hz.
Never connect to a DC
supply or any other power source. DO ensure that the TV is not standing on the mains lead.
DO NOT cut off the mains plug from this equipment, this incorporates a special Radio Inter-
ference Filter, the removal of which will impair its performance.
Hot / Moderate Climate Conditions
This device is suitable for working in hot and moderate climate conditions.
IF IN DOUBT PLEASE CONSULT A COMPETENT ELECTRICIAN.
DO
DO
read the operating instructions before you attempt to use the equipment.
DO
ensure that all electrical connections (including the mains plug, extension leads and in-
ter-connections between pieces of equipment) are properly made and in accordance with
the manufacturers instructions.
Switch off and withdraw the mains plug before making or changing connections.
DO
consult your dealer if you are ever in doubt about the installation, operation or safety of
your equipment.
DO
be careful with glass panels or doors on equipment.
DO NOT
DONT
remove any fixed cover as this may expose dangerous voltages.
DONT
obstruct the ventilation openings of the equipment with items such as newspapers,
table-cloths, curtains etc. Overheating will cause damage and shorten the life of the equip-
ment.
ENG-IDTV-JVC-1724W-17 INCH TFT LCD.230205.p65
24.02.2005, 08:19
2
Summary of Contents for InteriArt LT-23D50BK
